Wedding

Bunny Bride and Groom

1. Using serrated knife, cut the foam pieces as follows (hint: for smoother cuts, wax the knife blade first with an old candle): a. Cut 2" off tips of cones (lower body) b. Cut eggs in half lengthwise, and then cut 1" off pointed ends (feet) c. Cut 5" ball in half (upper body) d. Cut 2" balls in half (cheeks and tails) e. Roll the 1-1/2" balls into cylinders (hands)

 


Added: Fri Apr 11 2003
Views: 152
10 out of 10 stars

Pretty-as-a-Package Topiary

1. Wax knife blade with an old candle. Cut from sheets of STYROFOAM brand foam three squares in each of the following sizes: 9", 8", 3". Cut two 5" squares. Stack and glue foam squares together, creating "packages". Sand rough edges with a scrap of foam.

 


Added: Fri Apr 11 2003
Views: 194

Wedding Bell Centerpiece

1. Trace disc twice on wrong side of satin fabric; cut out, adding a 1/2" seam allowance all around. Place fabric circle, right side up, on disc; clip edges at 1/2" intervals. Spread thick white glue on tabs using toothpick; glue tabs to disc. (Hint: using toothpicks to spread glue will keep fingers � and the fabric, cleaner.) Repeat with other fabric circle, covering bottom of disc. Glue 7/8" satin ribbon around edge of disc; glue 7/8" lace trim over ribbon. Spray top and sides with glitter.

 


Added: Fri Apr 11 2003
Views: 167
10 out of 10 stars

Wedding Cake Wall Quilt

1. Wax serrated knife with candle stub or paraffin. If using a 24" x 36" foam sheet, cut to measure 18" x 30". If using two smaller sheets, cut each to measure 9" x 30". Insert six evenly spaced toothpicks along 9" edge; spread glue on edge and toothpicks; push two halves together, forming a single sheet 18" x 30".

 


Added: Fri Apr 11 2003
Views: 186